Skip to main content
Department of Information Technology

This page is a copy of research/systems_and_control/automatic/Lin_Wiener (Wed, 31 Aug 2022 15:08:01)

Linearizing control of non-linear Wiener systems

The Wiener model consists of a linear dynamic block in cascade with a static nonlinearity. Wiener models are sometimes used in the chemical process industry, for modeling of mixing dynamics followed by significantly faster chemical reactions. pH-control is a typical case. PH-control is also studied in this project.

Controllers for Wiener type processes can be designed with linear methods, following a non-linear step where the inverse of the non-linearity is applied to the reference signal and to the measured output signal as shown in Figure 1.


Figure 1: A control structure for linearizing control of Wiener systems.

The main objective of the project is to analyse the signal level dependent modeling errors that affect the control loop, when an identified model is applied for controller design. There are two main effects to consider. These are the inversion error due to inversion of the non-linearity, and the (differential) relative loop gain error. As it turns out these amplitude dependent errors are tied to the cascade structure of the Wiener model. The reason is that any method for identification of Wiener systems need to fix the static gain in one of the two cascaded blocks - or the identification problem becomes ill posed. This selection impacts the closed loop properties.

A main result obtained defines the amplitude dependent relative loop gain error formally. This error is proved to be related to the linearization error that affects the performance when the control loop of Figure 1 is applied. As an illustration of the importance of the signal amplitude, the controller of Figure 1 was applied for control of a simulated neutralization process. The model behind the process is described in 1 and 3. Figures 2 and 3 compares a linear controller that is tuned for the same bandwidth, without (Figure 2) and with (Figure 3) the linearizing pre-compensation of Figure 1. The purely linear controller becomes unstable in certain amplitude intervals, whereas the non-linear controller provides good performance.


Figure 2: Linear control of the pH control loop.


Figure 3: Linearizing control of the pH control loop.


1. T. Wigren and L. Brus, Reduction of amplitude dependent gain variations in control of non-linear Wiener type systems, 7th IFAC Symposium on Nonlinear Control Systems, NOLCOS 2007 , Pretoria, South Africa, pp. 730-735, August 22-24, 2007.

2. T. Wigren, Recursive prediction error identification using the nonlinear Wiener model, Automatica, vol. 29, no. 4, pp. 1011-1025, 1993.

3. T. Wigren, Recursive identification based on the nonlinear Wiener model, Ph.D. thesis, Acta Universitatis Upsaliensis, Uppsala Dissertations from the Faculty of Science 31, Uppsala University, Uppsala, Sweden, December, 1990.

Updated  2022-08-31 15:08:01 by Victor Kuismin.